百叶窗出现的问题与其解决办法：
百叶窗与框缝隙大：主要原因是安装时刨修不准及门窗框与地面不垂直，可将百叶窗卸下刨修至与框吻合后重新安装，如门窗框不垂直应在框板内垫片找直。
五金件安装质量差：原因是平开门的合页没上正，导致门窗扇与框套不平整。可将每个合页先拧下一个螺丝然后调整百叶窗与框的平整度调整修理无误后再拧紧全部螺丝钉。如合页螺丝短、螺丝一次钉入及倾斜都会导致门窗扇旷荡修理时应更换合适的螺丝钉。上螺钉时须平直螺丝应先钉入全长的1／3然后拧入其余2／3严禁一次钉入或倾斜拧入。
百叶窗开关不顺利：主要原因是锁具安装有问题应将锁舌板卸下用凿子修理舌槽，调整门框锁舌口位置后再安装上锁舌板。
推拉门窗滑动时拧劲：主要原因是上、下轨道或轨槽的中心线未在同一铅垂面内所致，应通过调整轨道位置，使上、下轨道或轨槽的中心线铅垂对准。
以上是我公司多年以来根据广大用户的使用情况，给您提供一些基本注意事项。如您遇到什么样的技术难题，欢迎来电咨询。
The shutters problems and its solution:
Shutters and gap big box: the main reason is that when installation shaved no door window frame is not vertical with the ground, the blinds can be unloaded shaved to reinstall after agreement with box, such as the door window frame not find straight vertical should be within the frame plate gasket.
Hardware installation quality is poor: why is flat door hinges not on, led to the doors and Windows set of fan and casing is not smooth. 可将每个合页先拧下一个螺丝然后调整百叶窗与框的平整度调整修理无误后再拧紧全部螺丝钉。 Such as short hinge screws, screw a screw into the and inclined can all result in a door to door repair universal suitable screws should be changed. 上螺钉时须平直螺丝应先钉入全长的1／3然后拧入其余2／3严禁一次钉入或倾斜拧入。
Shutter switch is not smooth, the main reason is that there is something wrong with the lock installed lock tongue plate should be unload groove with a chisel repair tongue, adjust the door lock tongue mouth location before you install the lock tongue plate.
Sliding door window sliding NingJin: the main reason is that upper and lower orbit or the center line of the rail slot is not in the same vertical surface, should by adjusting the position of the track, the upper and lower orbit or rail groove center line of the vertical alignment.
The above is my company over the years according to the usage of the masses of users, provide you with some basic considerations. If you encounter what kind of technical problems, welcome to inquire.